CHANGE OIL AND FILTER, CK AND FILL FLUIDS, CHECK AND SET AIR PRESSURE IN TIRES VISUAL INSPECTION OF OVERALL CONDITION OF VEHICLE
AXLE SHAFT – Remove & Replace – Front Axle,One Side – [Includes: Replace Transmission Output Seal.] – [NOTE: For Independent Suspension Type Axles, this operation consists of removal and installation, dissassembly and reassembly of the Axle Shaft Assembly
THRUST ANGLE ALIGN SET FRONT AND REAR WHEELS TO SPECIFATIONS
ELLIAS C. gave our service a 5 star review on 6/8/2021
Additional Maintenance Items for Severe Operating Conditions. BRAKE SYSTEM – INSPECT – [Brake pads, rotors, drums & linings: Check for wear, deterioration and fluid leaks. Replace any deteriorated or damaged parts immediately.] DRIVESHAFT BOOTS – INSPECT EXHAUST SYSTEM – INSPECT – [Visually inspect the exhaust pipes, muffler and hangers for leaks, cracks, deterioration, and damage. Tighten connections or replace parts as necessary.] PROPELLER SHAFT – INSPECT – [Check for damage, looseness, and grease leakage.] STEERING SYSTEM – INSPECT – [Steering Gear and Linkage, Axle and Suspension Parts, Drive Shaft Boots: Check for damage, looseness, and leakage of oil or grease. Under severe driving conditions, inspect more frequently.] SUSPENSION COMPONENTS – INSPECT – [Axle and suspension parts: Check for damage, looseness, and leakage of oil or grease. Under severe driving conditions, inspect more frequently. Inspect front suspension ball joints.]
CHANGE OIL AND FILTER, CK AND FILL FLUIDS, CHECK AND SET AIR PRESSURE IN TIRES VISUAL INSPECTION OF OVERALL CONDITION OF VEHICLE
DISC ROTOR – Remove & Replace – Front,Both Sides – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing.]
DISC ROTOR – Remove & Replace – Rear,Both Sides – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing.]
MOUNT AND BALANCE 4 TIRES REPLACE VALVE STEMS DIPOSE OF OLD TIRES
SHANNON S. gave our service a 5 star review on 10/18/2019
BATTERY – Remove and Replace – All Applicable Models – [Includes: Test.]
POWER STEERING PRESSURE SWITCH – Remove and Replace – All Applicable Models
DISC ROTOR – Remove and Replace – Rear,Both – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing.]
MOUNT AND BALANCE 4 TIRES REPLACE VALVE STEMS DIPOSE OF OLD TIRES
THRUST ANGLE ALIGN SET FRONT AND REAR WHEELS TO SPECIFATIONS
TIE ROD and /OR END – Remove and Replace – Outer,One Side – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing Inner Tie Rod End(s) on some models
MATTHEW G. gave our service a 5 star review on 2/27/2019